Cleaning & Maintenance - RC Lighting HBLED Instructions D'installation

HBLED HSLED HNLED INSTALLATION INSTRUCTIONS
Thank you for buying RC lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-722-1000 or email: marketing@rclighting.ca
ON-OFF WIRING
Universal voltage driver permits operation at 120V thru 277V,
50 or 60 Hz. Units ordered with (/347V) suffix are 347V. For Non-
Dimming, follow the wiring directions as in fig. 1.
1. Connect the black fixture lead to the (+) LINE supply lead.
2. Connect the white fixture lead to the (-) COMMON supply
lead.
3. Connect the GROUND wire from fixture to supply ground.
(+)LINE
(-)COMMON
GROUND GROUND
TROUBLESHOOTING
1. Check that the line voltage at fixture is correct. Refer to
wiring section.
2. Check the fixture is grounded properly.
3. If sensor is connected, check if it is working properly.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1. Clean lens & fixture with non-abrasive cleaning solution.
2. Do not open fixture to clean the LED. Do not touch the
LED.
3. Keep leaves and debris out of hood.
Patent: Pending: Pat. pending
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during
installation, operation or maintenance.
Easy Installation & Product Help
Tech Help Line
©2014 RC LIGHTING, LLC
Call our experts 888 722-1000
Northvale, New Jersey 07647 USA
HBLED HSLED HNLED-IN-0514 RCL
®
BLACK
LIGHT
WHITE
Fig. 1
FIXTURE
0-10V DIMMABLE WIRING
Universal voltage driver permits operation at 120V thru
277V, 50 or 60 Hz. 0-10V control wires must be rated for 300V
minimum. For 0-10V Dimming, follow the wiring directions as
in fig. 2.
1. Connect the black fixture lead to the (+) LINE supply lead.
2. Connect the white fixture lead to the (-) COMMON supply
lead.
3. Connect the GROUND wire from fixture to supply ground.
Do NOT connect the GROUND of the dimming fixture to
the output.
4. Connect the purple fixture lead to the (V+) DIM lead.
5. Connect the gray fixture lead to the (V-) DIM lead.
6. Cap the yellow fixture lead, if present. Do NOT connect.
rclighting.ca
Visit our website for product info
email
Answered promptly sales@rclighting.ca
Fig. 2