Teka RVI 30097 GBK Mode D'emploi page 36

 Internal light

In order to reduce energy consumption, this wine cabinet will automatically switch off the
LED lights after 10 minutes.

If you want the LED light to remain on continuously, this is possible. Please press and
hold the " " button for 5 seconds, the display will show "LP".After 4 seconds the
display will revert back to normal and the light will remain on until manually switched off.

If you want to revert back and conserve energy (recommended), please press and hold
the " " button for 5 second, the display will show "LF",after 4 seconds the display
will revert back to normal, and the light will automatically switch off after 10 minutes.
 Function Instruction

Temperature Recollection Function
In the event of a power interruption, wine cooler can remember the previous
temperature settings, and when the power is recovery, the cooler temperature will go
back the same setting temperature as power off.

Temperature Alarm
If inner temperature is higher than 23°C, The "HI" is shown in display panel, and the
buzzer alarm after one hour continuously. It inform that the inner temperature is too high,
please check the reason.
If inner temperature is lower than 0°C, The "LO" is shown in display panel, and the
buzzer alarm and the malfunction indicator light light at the same time.
 Note

If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the Wine Cooler will
not start.
 When you use the wine cooler for the first time or restart the wine cooler after having
been shut off for a long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED readout. This is normal and
it is due to the length of the activation time. Once the wine cooler is running for a few
hours everything will be back to normal.
 Shelves

To prevent damaging the door gasket, make sure to have the door all the way opened
when pulling shelves out of the rail compartment.

To Remove Shelves:
1. Fully extend the shelf you wish to remove (Fig. A)
2. Lift the front of the shelf up (Fig. A)
3. Holding the shelf track, push the shelf in, then up to release from the rear dampers
(Fig. B)
34