Care And Cleaning; Troubleshooting - HAMPTON BAY CH-7830-03 Guide D'utilisation Et D'entretien

Care and Cleaning

□
Use a dry cloth to clean the doorbell and push button.
□
Do not use cleaners or polishes.
□
Do not use any fluids on the doorbell or push button.

Troubleshooting

Problem Possible Cause
□
The doorbell does
not sound.
□
□
□
The batteries
seem okay, but
the doorbell does
not work after
□
installation.
□
□
The doorbell
sounds when not
intended (false
triggers).
The batteries are not
installed correctly.
The batteries are dead.
The push button and
doorbell are not synced.
The doorbell or push but-
ton is mounted on metal
or near metal studs.
The doorbell is mounted
near a concrete floor or
wall.
The doorbell and push
button are installed too
far apart.
The doorbell is receiving
interference from another
wireless device.
Solution
□
Make sure the batteries are installed according to the
diagram inside the push button and doorbell.
□
Check the charge of the push button and doorbell bat-
teries and replace them if necessary.
□
Sync the push button and doorbell:
□
Press and hold the center button "
doorbell until the doorbell sounds a "Beep-Beep".
□
Press the push button within 30 seconds. The
doorbell will sound a "Beep-Beep" tone to indicate
the push button is synced.
□
Press the push button to ensure operation.
□
Metal reduces transmission range. Use 1/4 in. to 1/2 in.
(6 to 13 mm) wood shims to move the doorbell or push
button away from the metal surface.
□
Concrete may reduce range. Move the doorbell away
from the concrete surface.
□
Locate the doorbell closer to the push button.
□
Reset the doorbell and push button:
□
Remove the push button batteries. Wait 30
seconds.
□
Press and hold the push button for 10 to 15 sec-
onds within 60 seconds after installing the battery
into the push button.
□
Press and hold the center button "
doorbell until the doorbell sounds a "Beep-Beep-
Beep-Beep".
□
To re-sync the push button and doorbell, press and
hold the center button "
the doorbell sounds a "Beep-Beep".
□
Press the push button within 30 seconds. The
doorbell will sound a "Beep-Beep" tone to indicate
the push button is synced.
□
Press the push button to ensure operation.
7
Please contact 1-844-760-3644 for further assistance.
" on the
" on the
" on the doorbell until
HAMPTONBAY.com