Operation
1
Adjusting the doorbell volume
The doorbell (A) has an adjustable volume control.
Press and release the "+" or "–" button to adjust the
volume one step at a time. Press and hold the "+" or
"–" button to continuously adjust the volume.
2
Adding tunes to the doorbell
The suggested tune length is 2-15 seconds. The
maximum tune length is 20 seconds. If the tune is
longer than 20 seconds, only the first 20 seconds will
play.
□
Connect the USB cable (FF) to the doorbell (A)
and the computer.
□
Locate and open the external drive folder.
□
Drag the desired tune to the doorbell (A) drive.
□
Disconnect (eject per computer operating
system) the doorbell (A) from computer.
□
Remove the USB cable (FF).
3
Selecting a tune
The doorbell (A) allows you to customize your doorbell
sound with front door tunes. The default setting for the
front door push button (B) is "Ding-Dong".
□
Press and release the arrow buttons to cycle
through the tune list one tune at a time ("
scrolls down the list; "
□
Stop when the desired tune plays. The last
tune played will play each time the front door
push button (B) is pressed.
4
Setting the wireless push
button
The wireless push button (B) has two options for tune
selection: Play the selected "FRONT" door musical
tune or play the "REAR" door designated tune (Ding).
□
Remove the single jumper (AA) inside the push
button (B) to play the selected musical tune.
□
Add the single jumper (AA) inside the push
button (B) to play only the Ding tune.
"
" scrolls up the list).
IMPORTANT: The door chime will not play when connected to the
computer.
FF
NOTE: To listen to the selected tune, press and release
the center button "
Remove jumper to
set as the "FRONT" door
6
A
".
B
Add jumper to set
as the "REAR" door
A
A
AA