Jetvent Fans JVEC-ULP Manuel D'utilisation page 2

WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, and INJURY TO PERSONS: Installation work and electrical wiring must be
done by qualified person(s) in accordance with all applicable codes and standards.
CAUTION: The installation of a JetVent Fan must be in accordance with the requirements specified in this installation manual and with
any additional requirements set forth by the National Electric Code (NEC), ANSI/NFPA 70-1999, and all local codes. If you are unfamiliar
with electrical codes use a qualified electrician to perform this work.
WARNING: Risk of fire, electric shock, death or injury to persons during cleaning and user maintenance. Disconnect the fan from the
power supply before servicing or moving the fan.
WARNING – DANGER DUE TO RESIDUAL ELECTRIC CURRENT: When the motor runs due to air flowing through the fan, or if it continues to
run down after being turned off, dangerous voltages of over 50 Volts can be present on the motor's internal connections. Even after
disconnecting the power, life-threatening charges can appear between the protective ground and the mains connection. WAITING PERIOD
OF 3 MINUTES! Danger of death exists even after switching off the fan by directly touching the energized parts, or by touching parts that
have become energized due to faults. The controller housing may only be removed or opened when the power line has been switched off
and a waiting period of three minutes has elapsed since switching it off.
WARNING: To reduce the risk of fire, electric shock, or personal injury, mount the fan directly to a structural framing member that has
sufficient strength to support at least three times the hanging weight of the fan. If uncertain, a certified engineer or architect should
conduct an analysis of the installation prior to purchasing the fans. While ZOO Fans provides guidelines for installation, it is the sole
responsibility of the owner to ensure the safety of the installation and that it complies with all relevant codes.
WARNING: To reduce the risk of fire, electric shock, and injury to persons, JetVent Fans must be installed only with controllers supplied
by ZOO Fans. Other parts cannot be substituted—they may cause injury and will void product warranties.
Motor is NOT suitable for use with solid-state speed controls.
CAUTION: When service or replacement of a component in the fan requires the removal or disconnection of a safety device, the safety
device is to be reinstalled or remounted as previously installed.
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
b) Before servicing or cleaning unit, switch power off at service panel and lock the service disconnect to prevent power from being switched
on accidentally. When the service disconnect cannot be locked, securely fasten a prominent warning device, such as a large tag, to the
service panel and apply tape to secure the service disconnect in the OFF position.
WARNING: Do not install this fan in a cooking area.
WARNING: Do not operate the fan in spaces with hazardous or Explosive Material and Vapors.
DANGER: Rotating equipment. Death, severe injury and property damage may result.
•
The safety grills on the fan must remain securely attached.
•
Do not wear loose or hanging clothing, jewelry, etc., tie together long hair and cover it—avoid being tangled in the blades!
WARNING: Stay alert and use common sense when installing, operating and servicing fans. Do not operate, install, or service fans if
tired or under the influence of drugs, alcohol, or medication.
CAUTION: Only operate the fan within the ranges specified on the motor's type plate.
jetventfans.com
IMPORTANT SAFETY INFORMATION
READ AND SAVE THESE INSTRUCTIONS
JetVent is a Registered Trademark