American Lighting POLAR 2 MINI NEON Instructions Pour L'installation page 4

120V POLAR 2 MINI NEON, BULK REELS
INSTALLATION INSTRUCTIONS
MINI-P2-NF Series
MOUNTING
1. Make mounting clips using cut pieces of track or order clips (MINI-P2-NF-CLIPS, 10 per pack, sold separately) for curves and shapes on a
flat mounting surface; or for straight line applications, use MINI P2-NF-CHAN-3 (3ft aluminum channel sold separately).
2. Make sure that the distance between any two parallel runs of lighting is at least 1/2" apart.
3. Gently press flexible light into track, channel and/or clips so that it snaps into place.
TO REPLACE FUSE (SEE FIGURE 6):
This plug contains an electrical fuse as a safety feature.
1. Disconnect power before replacing the fuse.
2. Grasp plug and remove from the receptacle or other outlet device.
3. Do not unplug by pulling on the cord.
4. Slide open the fuse access cover (See figure 6).
5. Remove old fuse carefully.
6. Never attempt to replace the fuse with a higher wattage fuse. Use
only 8Amp 125Volt fuse. Failure to do so may be a fire hazard. (One
spare fuse is included; stored inside plug for convenience)
7. Set new fuse in holder and close fuse access cover.
DO NOT TWIST, HANG VERTICALLY, SUSPEND UNSUPPORTED IN THE MIDDLE, BEND UPWARDS (ARCH) OR DOWNWARDS (DIP).
©2018 American Lighting, Inc. REV1828 www.AmericanLighting.com
MINIMUM BEND RADIUS FOR SIDE-TO-SIDE BEND IS SHOWN BELOW.
×
FIGURE 6
Slide open fuse access cover as shown.
×
×
Page 4 of 4 11775 E. 45th Ave. Denver, CO 80239 Ph: 1-800-880-1180 Fax: 303-695-7633
Fuse is inside plug.
MINIMUM BEND
RADIUS = 50mm