American Lighting PLT-11823 Instructions D'installation

120V
INSTALLATION INSTRUCTIONS
PLT-11823
WARNING
These products may represent a possible shock or
fire hazard if improperly installed or attached in any
way. Products should be installed in accordance
with these instructions, current electrical codes,
and/or the current National Electric Code (NEC).
WARNING
The electrical rating of this product is 120V AC. The
installer must determine whether power supply
is appropriate at the luminaire before installation.
Ensure power supply is turned off at the fuse box
or circuit breaker prior to attempting installation or
servicing of the fixture.
PRE-INSTALLATION
CAUTION -
To reduce the risk of fire, electric shock, or injury to persons: Be sure that the power supply is turned off at the fuse box or circuit
breaker before attempting installation or servicing of the fixture.
CAUTION -
To reduce the risk of fire, electric shock, or injury to persons: Use with 5" or 6" recessed cans (recessed housings) only. Do not
attempt to alter for other sizes or purposes. Before beginning installation, confirm housing compatibility by checking the interior of the housing for
a manufacturer's part number and specifications; or measure the diameter of the housing. The recessed housing must have a minimum measured
inside diameter (opening) of 5-1/4" and a maximum measured inside diameter (opening) of 6-3/4". Turn power OFF from the electrical panel before
starting installation.
INSTALLATION (See Figures 1-4):
1. Remove existing bulb and trim if applicable.
2. Confirm the LED Retrofit Downlight is compatible with the existing 5" or 6" recessed housing as outlined above.
3. Screw Edison socket adapter into back of existing housing. See Figure 1.
4. Connect the retrofit downlight's plastic connector to the Edison socket adapter's plastic connector making sure the mating parts snap together.
5. Use the CCT slider switch on the back of the fixture to set the desired color temperature for the light. See Figure 3.
6. Squeeze the fixture's torsion springs together (one on each side of the downlight) and install into torsion spring receiving clips inside housing.
7. Carefully route wires into housing and push retrofit downlight up flush to ceiling. See Figure 2.
FIGURE 1
Edison socket adapter
SAFETY INFORMATION
• Read all instructions before beginning. Save these instructions for future use.
• To reduce the risk of fire, electric shock, or injury to persons, pay close attention
• Installation of this fixture requires knowledge of recessed lighting luminaires and
• Supply conductors (power wiring) connecting the fixture must be rated for a
• Do not make or alter any open holes in wiring enclosures, nor in any electrical
• Do not alter, relocate, or remove wiring, lamp holders, power supply, or any
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet
• To avoid electrical shock, do not turn on fixture with missing or damaged lens.
• This downlight is suitable for use in wet locations; and is rated Type IC.
• There are no serviceable parts inside of the LED module.
• This fixture is suitable for use in dimming circuits: TRIAC/CL/ELV
Existing FIGURE 2
housing
to this manual and stay within its guidelines when using this product.
their electrical systems. If not qualified or uncertain, do not attempt installation.
Contact a qualified electrician.
minimum of 90°C (194°F).
components during installation.
other electrical component.
metal or other sharp objects.
Torsion spring
receiving clips
Ceiling
Page 1 of 4
FIGURE 3