Euroflex WAVE HC049 Mode D'emploi page 12

English
individually welded. Even with a loss of a few individual rings, the glove must be repaired to ensure safety.
The repair may only be carried out by specialised companies which can restore the original condition. Please
use our RENOFLEX service, which guarantees quality restoration. Continuous loss of rings in several places
indicates that the ring braid is largely weakened (due to wear, fatigue, and the likes). The glove must then be
withdrawn from use. For safety reasons, a specialist company should decide whether the repair is still eco-
nomically viable and can be advocated.
EUROFLEX
®
formance spring steel. It is very durable and can be cleaned at up to 100° C. It is resistant to the usual was-
hing and disinfecting agents, mild acids and bases.
The steel band can be broken or torn through improper use. The glove must then no longer be
used and the band must be replaced with a new one. Spare bands can be obtained from your
specialist dealer.
Cleaning
EUROFLEX
®
band. If no special glove washer is available, we recommend cleaning it with warm water, at approx.
50 °C, by adding commercially available cleaning agents. Gloves and wristband should be brushed
off vigorously. After the protective glove has dried, it must be treated with a disinfectant commonly
used in the food industry. For storage, the gloves should be suspended, if possible, in a special sto-
rage cabinet.
During each cleaning, the EUROFLEX
the belt or holes in the fabric. Likewise, the fabric should be checked for weakened spots. Gloves with dama-
ged or weakened ring fabric must not be used and must be set aside for repair.
All EUROFLEX
®
detergents, fatty acids can reduce the required protection level. Also wear, aging and damage can influence
the intended use. If in doubt, give the glove to a specialist company for inspection.
These safety gloves are products subject to mandatory safety-testing! They may only be
used in their originally delivered
Guarantee
EUROFLEX
®
complaints, we are obliged only to replace or repair defective products. Each EUROFLEX
safety glove has a unique serial number on a permanently affixed sticker, ensuring
seamless traceability. This sticker is part of the warranty and must not be removed under any cir-
cumstances.
We assume a 2-year-guarantee (xtrem 3 years) for the welds of the ring mesh. Holes in the mesh
appearing due to no particular cause will be repaired free of charge.
safety gloves have a stainless steel band made from wave-shaped high-per-
safety gloves must be cleaned completely after use, including the wrist-
®
safety gloves are a quality product. Nevertheless, chemical compounds,
safety gloves are delivered in perfect condition. Should you have any
12
safety gloves must be inspected for any defects in
®