Velleman DVR4H3 Guide D'installation Rapide page 8

live audio channel 1 .. 4 enabled
audio channel disabled
digital zoom on (yellow) / off
LAN connected / Internet connected / no network connection
USB flash drive connected
key lock on
sequence mode
recording mode
administrator logged on
Note that actual screen icons might differ slightly from the ones shown above.
"#$% 4.&" 6)0
+(.: only available when USB mouse is connected.
• Move the pointer towards the left of the monitor to open the quick menu bar:
Open channel switch panel.
Show playback control panel.
Zoom4in mode (select desired channel first before entering zoom4mode).
Select audio channel (live mode only live channels can be selected).
Enter PTZ mode and show PTZ control panel
Click to show the power off panel to either halt or reboot the system.
.$+0-#&,
• Check whether the camera(s) is (are) properly connected and a HDD is present inside the device.
• When the auto4recording and pre4alarm functions are enabled, the device will start recording
images.
• Default the recording icon (
• In case the motion or alarm detection is activated and a motion or alarm is detected, the motion
( ) resp. alarm (
• When timed recording is enabled, the timed recording icon (
LED is on.
• Default, the device is in HDD overwrite mode and the icon (
18/01/2012
) is shown.
) icon is shown.
playback audio channel 1 .. 4 enabled
(yellow)
timer recording
USB mouse connected
Hard disk overwrite (default)
PTZ mode
motion mode
alarm mode
operator logged on
) is showed and the timed recording
) is shown.
8
Rev. 01
©Velleman nv