Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Wiring Diagram
1.With DALI bus
L N
DA
DA
DALI bus
2.With PUSH dimmer
L N
AC PUSH
3.With 1-10V dimmer
L N
1-10V
Control Unit
Current draw < 1mA
L
N
UNIDRIVER50
PRI
N
200-240V~
LED Driver Constant Current
DALI & AC Push & 0/1-10V
L
PRI:200-240V~
50/60Hz
0.27A
SEC:
250mA,8-48VDC,Max.12W
800mA,8-48VDC,Max.38.4W
300mA,8-48VDC,Max.14.4W
850mA,8-48VDC,Max.40.8W
350mA,8-48VDC,Max.16.8W
900mA,8-48VDC,Max.43.2W
DA/L
400mA,8-48VDC,Max.19.2W
950mA,8-48VDC,Max.45.6W
DALI
500mA,8-48VDC,Max.24W
1000mA,8-48VDC,Max.48W
DA/N
600mA,8-48VDC,Max.28.5W
1100mA,8-45.5VDC,Max.50W
700mA,8-48VDC,Max.33.6W
1200mA,8-41.6VDC,Max.50W
750mA,8-48VDC,Max.36W
1300mA,8-38.5VDC,Max.50W
DA/N
DALI
DA/L
NC
PUSH DIM
λ
>
0
.
93@230VAC
Ta:-20~+45℃
Tc:75
℃
L
N
For indoor use only
SEC
0/1-10V
GND
L
N
UNIDRIVER50
PRI
200-240V~
N
LED Driver Constant Current
DALI & AC Push & 0/1-10V
L
PRI:200-240V~
50/60Hz
0.27A
SEC:
250mA,8-48VDC,Max.12W
800mA,8-48VDC,Max.38.4W
300mA,8-48VDC,Max.14.4W
850mA,8-48VDC,Max.40.8W
350mA,8-48VDC,Max.16.8W
900mA,8-48VDC,Max.43.2W
DA/L
400mA,8-48VDC,Max.19.2W
950mA,8-48VDC,Max.45.6W
DALI
500mA,8-48VDC,Max.24W
1000mA,8-48VDC,Max.48W
DA/N
600mA,8-48VDC,Max.28.5W
1100mA,8-45.5VDC,Max.50W
700mA,8-48VDC,Max.33.6W
1200mA,8-41.6VDC,Max.50W
750mA,8-48VDC,Max.36W
1300mA,8-38.5VDC,Max.50W
DA/N
DALI
DA/L
NC
PUSH DIM
λ
.
>
0
93@230VAC
℃
L
Ta:-20~+45℃
Tc:75
N
For indoor use only
SEC
0/1-10V
GND
L
N
UNIDRIVER50
PRI
N
200-240V~
LED Driver Constant Current
DALI & AC Push & 0/1-10V
L
PRI:200-240V~
50/60Hz
0.27A
SEC:
250mA,8-48VDC,Max.12W
800mA,8-48VDC,Max.38.4W
300mA,8-48VDC,Max.14.4W
850mA,8-48VDC,Max.40.8W
350mA,8-48VDC,Max.16.8W
900mA,8-48VDC,Max.43.2W
DA/L
400mA,8-48VDC,Max.19.2W
950mA,8-48VDC,Max.45.6W
DALI
500mA,8-48VDC,Max.24W
1000mA,8-48VDC,Max.48W
DA/N
600mA,8-48VDC,Max.28.5W
1100mA,8-45.5VDC,Max.50W
700mA,8-48VDC,Max.33.6W
1200mA,8-41.6VDC,Max.50W
750mA,8-48VDC,Max.36W
1300mA,8-38.5VDC,Max.50W
DA/N
DALI
DA/L
NC
PUSH DIM
λ
>
0
.
93@230VAC
Ta:-20~+45℃
Tc:75
℃
L
N
For indoor use only
SEC
0/1-10V
GND
Safety & Warnings
• DO NOT install with power applied to device.
• DO NOT set the operation current with power applied
• DO NOT expose the device to moisture.
Operation
1. Dimming Interface Selection
1.1. The LED driver supports 3 kinds of dimming input: DALI, Push, 1-10V.
1.2. Please select any of the 3 dimming interfaces to wire each time.
1.3. To connect a new dimming interface, previously connected dimming interface must be disconnected.
1.4. DO NOT connect more than 2 (including 2) dimming interfaces simultaneously.
2. DALI Address Assigned by DALI Masters
While connected with DALI interface, 1 DALI address can be assigned by DALI Master controller automatically, please
refer to user manuals of compatible DALI Masters for specific operations.
PUSH Dimmer Mode
While connected with a AC PUSH, the driver will be in Push Dimmer Mode, operations under Push Dimmer Mode are as
LED light
follows:
3.1. Click the button to switch ON/OFF
3.2. Press and hold down the button to increase or decrease light intensity to desired level and release it, then repeat the
operation to adjust light intensity to opposite direction. The dimming range is from 1% to 100%.
3.3. Memory function after power off or power failure enables the device to memorize the status before power off while
power on again.
PUSH Dimmer Mode synchronizing when using multiple drivers:
When using the push function on multiple drivers, the push function must be synchronized.
If some drivers turn on while others turn off:
Step 1: keep the push button pressed
LED light
Drivers that are switched on go to 0% dimming, then the drivers that are switched off go to 100% dimming.
Only release the push button when the drivers that are still active have reached their maximum level.
Step 2: briefly press the push button
The drivers that now operate at maximum level will be disabled. All drivers must now be disabled.
Step 3: keep the push button pressed
All drivers will now dim from 0 to 100%. Release the push button when all drivers have reached their maximum level.
All drivers are now synchronized.
Product Dimension
LED light
LED Current Selection
1 2 3 4
ON
250mA
300mA
350mA
400mA
OFF
500mA
600mA
700mA
750mA
1 2 3 4
800mA
850mA
900mA
950mA
1000mA
1100mA
1200mA
1300mA
164.6 mm
Publicité
Table des Matières
