Avis; Fcc Statement - VisionTek VT2900 Manuel De L'utilisateur

AVIS

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning: Where shielded interface cables or accessories have been provided with the product or specified additional com-
ponents or accessories elsewhere defined to be used with the installation of the product, they must be used in order to ensure
compliance with FCC. Changes or modification to product not expressly approved by VisionTek Products, LLC could void your
right to use or operate your product by the FCC.
Déclaration IC : CAN ICES-003 (b) / NMB -003 (B)
Cet appareil est conforme aux normes RSS exemptées de licence d'Industrie Canada. L'exploitation est soumise aux deux
conditions suivantes : (1) ce périphérique peut ne pas provoquer d'interférences, et (2) cet appareil doit accepter toute inter-
férence, y compris les interférences pouvant entraîner un fonctionnement indésirable de l'appareil.
14