Hoover HOO C1415 Mode D'emploi page 3

1-4
Rotate cord protector (F) as shown.
1-6
Press cord into place at each of the
three notches indicated and note
correct positioning of (F).
Do not plug cleaner in until assembly
is totally complete.
1-8
B
C
Slide extensions (B) on lower back
of cloth bag into slots (C) in lower
handle.
1-11
H
On upper handle, grasp bag clip
retainer (H) and pull down firmly.
Hook bag clip (I) into slot in retainer.
1-5
F
With (F) pointing downward (toward
back of handle), press groove (H) into
slot (I).
Pull cord tight.
F
Note proper placement of
cord at notch as shown.
1-9
B
C
Insert the two screws at area shown (D).
Tighten screws.
Step 4 Attach handle
1-12
I
J
Note location of tapered rails (J) on
dirt cup support (K) and on lower
handle.
F
I
H
D
K
F
Step 3 Attach dirt
cup assembly
1-7
A
Release dirt cup latches (A) by
pulling them outward.
Remove cup and set it aside.
1-10
E
Note round opening (E) and hooks (F)
on back of cloth bag. Place opening
over dirt tube (G).
Press down firmly to snap hooks into
handle.
1-13
L
M
Slide rails on support onto rails (L)
on lower handle until support snaps
past the lock tab (M).
Continued ‹
F
G
3