Publicité
Les langues disponibles
Les langues disponibles
Install the control station and receiver where the door is
visible, but away from the door and its hardware. When a
receiver is used to activate a commercial door opener, a
reversing edge MUST be installed on the bottom of the door.
Failure to install a reversing edge under these circumstances
may result in SERIOUS INJURY or DEATH to persons trapped
beneath the door.
To use the remote control with a
3-channel receiver and 3-button door
AVERTISSEMENT
control to operate a commercial door
opener
ATTENTION
3 Channel Receiver
1. Use a screwdriver to pry open the
receiver cover (see illustration).
NOTE: The slide switch is factory set to the
N.C. position (otherwise the opener will not
operate). Verify this setting.
2. Select a remote control push button to
STOP the opener. (RED is
recommended.) Press and hold the
selected remote push button.
3. Then press and release the "learn"
button labeled "A" on the receiver. The
adjacent indicator light will FLASH.
Release the remote push button.
Repeat the procedure above with the yellow remote push
button and receiver "learn" button "B" to program the
CLOSE operation; and again with the green remote push
button and receiver "learn" button "C" to program the
OPEN function of the opener.
Return the front cover to the receiver.
(For this application, code switch settings need not be
changed.)
NOTE: If a remote control push button is not pressed
within 30 seconds, the indicator light adjacent to the
selected "learn" button will turn OFF. In that case, repeat
the programming.
114A3102B
WARNING
CAUTION
© 2006, The Chamberlain Group, Inc.
Replacing the remote control battery
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
The 12 volt battery should
produce power for 1 year. To
replace the battery, slide the
battery compartment cover.
Dispose of old batteries properly.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this
receiver and/or remote control are prohibited, except for changing the code setting or replacing the
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
FOR SERVICE DIAL OUR TOLL-FREE NUMBER:
U.S.: 1-800-528-2817
CANADA: 1-800-654-4376
All Rights Reserved
WARNING
WARNING
WARNING
CAUTION
AVERTISSEMENT
AVERTISSEMENT
AVERTISSEMENT
ATTENTION
Publicité
