hestan AGPO33LK-TQ Instructions D'installation page 8

ASSEMBLY
6. Re-attach the front frame / landing ledge assembly to the oven with the 2 OUTER screws, and re-
install the 2 thumbscrews as well. Slide / pull the cord as needed to arrange it as shown below. You
will tuck the remainder of the cord under the unit so it reaches the back.
EN
Leaving a little slack on the cord up inside the frame, position the large strain relief as near as possible
to the large hole under the landing ledge. Use a pair of large pliers to press the two halves of the
plastic together which grip the cord, then push the strain relief into the hole until it snaps in place.
You may now tighten the lock-nuts on the ignition module and gas valve. Re-install the 2 screws on
the bottom edge.
*
For stainless steel units, the frame was never removed. Just re-install the
landing ledge using the OLD bolts, and install the large strain relief as
described above. Arrange the cord as shown above. You will tuck the
remainder of the cord under the unit so it reaches the back.
7. Re-install the AAA battery (- Negative end goes in first)
and spark module cap.
Re-install the knob on the gas valve.
8
©2022 Hestan Commercial Corporation
(CONT.)
RE-INSTALL
2 THUMBSCREWS
& 2 OUTER SCREWS
2 SCREWS
CAREFULLY INSTALL THE
PLASTIC STRAIN RELIEF
IN THE HOLE.
DO NOT PULL FURTHER
ON THE CORD.
TIGHTEN
LOCK-NUTS