hestan AGPO33LK-TQ Instructions D'installation page 5

ASSEMBLY
(CONT.)
2. The lighting assembly is shown fully connected in the photo below as a reference. If not already
done so, disconnect the white connector, pink connectors at the switch, and remove the small nut
to disconnect the wire to the ground lug.
*
For Stainless Steel units,
begin here.
PINK CONNECTORS
ON LIGHT SWITCH
3. Route the wire harness white connector through the round hole in the landing ledge, and then up
inside the front frame until the white connector appears in the opening at the top of the frame as
seen here. If needed, use a small piece of string to help route the wire up. Leave enough slack in the
cord to allow the white connector to reach the extreme left side of the opening. Now attach the
landing ledge to the frame with 4 NEW bolts supplied, using a 7/16" wrench. Do not install the large
strain relief (shown here in green), until all electrical connections have been completed and tested.
Use care when handling the various painted items to avoid scratches during assembly.
*
Do this for stainless
steel units.
WHITE
CONNECTOR
GROUND LUG
LANDING
LEDGE
4 NEW BOLTS
POWER
CORD
WHITE CONNECTOR
FRONT FRAME
©2022 Hestan Commercial Corporation
EN
ROUND
HOLE
LARGE
STRAIN
RELIEF
5