ERARD 7976 Manuel D'utilisation page 6

Récepteur (RX)
1. OUTPUT LED: The output status indicating lamp. This red LED
illuminates when the TV plugs in with HDMI cable.
2. HDMI OUT: HDMI output port. This slot is where you connect the
HDTV or monitor with HDMI cable.
3. ETHERNET: This slot provides Internet signal from transmitter or
to transmitter.
4. RS232: Phoenix jack provides Serial port control signal from
transmitter or to transmitter.
5. DC IN: Plug the 24V DC power supply into the unit.
6. IR RX: Chanel 2 IR Receiver. Connect with Wideband IR Rx.
7. IR TX: Chanel 1 IR Transmitter. Connect with Wideband IR Tx.
8. LINK LED: The connection status indicating lamp.
※Illuminate: The Transmitter and Receiver are in good connections
※Flashing: The Transmitter and Receiver are in poor connections
※Dark: The Transmitter and Receiver are in no connections
9. HD BaseT IN: Standard HD BaseT signal input port. Connect HD
BaseT transmitter with a UTP cable following the standard of
IEEE-568A or IEEE-568B.
10. DATA LED: The data status indicating lamp.
※Illuminate: The HDMI signal with HDCP.
※Flashing: The HDMI signal without HDCP.
※Dark: No HDMI signal.
5