ERARD 7976 Manuel D'utilisation page 5

V. Commandes et fonctions
Emetteur (TX)
1. INPUT LED: The input status indicating lamp. This red LED
illuminates when the HDMI signal plugs in.
2. HDMI IN: HDMI input port. This slot is where you connect the HDMI
source.
3. ETHERNET: This slot provide Internet signal from receiver or to
receiver.
4. RS232: Phoenix jack provide Serial port control signal from
receiver or to receiver.
5. DC IN: Plug the 24V DC power supply into the unit.
6. IR RX: Chanel 1 IR Receiver. Connect with Wideband IR Rx.
7. IR TX: Chanel 2 IR Transmitter. Connect with Wideband IR Tx.
8. LINK LED: The connection status indicating lamp.
※Illuminate: The Transmitter and Receiver are in good connections
※Flashing: The Transmitter and Receiver are in poor connections
※Dark: The Transmitter and Receiver are in no connections
9. HD BaseT OUT: Standard HD BaseT signal output port. Connect HD
BaseT receiver with a UTP cable following the standard of
IEEE-568A or IEEE-568B.
10. DATA LED: The data status indicating lamp.
※Illuminate: The HDMI signal with HDCP.
※Flashing: The HDMI signal without HDCP.
※Dark: No HDMI signal.
4