Beper 40.332 Manuel D'instructions page 9

EN
Rechargeable beard trimmer Use instructions
Only the blades can be washed under tap water. Do not immerse
the appliance into water, and do not rinse it under tap water.
Do not use abrasive or corrosive detergents to clean the appliance
and the blades.
Product description Fig.A
1. Cutting length selector
2. ON/OFF switch
3. Charging indicator
4. Comb attachment (1-10mm)
5. Lubricating oil bottle
6. Cleaning brush
Use instructions
Charging of the appliance
Make sure tha the appliance is switched off before charging it.
Insert the power cable in the connector found at the bottom of the appliance, and connect it to a USB plug (USB
wall adapter or PCS USB port). USB wall adapter is not included.
The charging indicator turns on, and it will stay on until the appliance is disconnected from the USB plug.
Normal charging time is 8 hours. Do not charge the appliance for a longer period of time, to avoid damaging the
battery.
8 hours of charging allow up to 60 minutes of continuous use of the appliance.
To ensure maximum life of battery, we recommend the following:
Do not charge the appliance between use sessions; allow the battery to discharge completely.
Discharge completely the batteries at least twice a year (slide the ON/OFF switch to the ON position and let the
appliance run until it stops)
Important! Do not use the appliance while charging
Avoid charging the appliance in direct sunlight or close to direct heat sources.
Use of the appliance
Make sure the appliance is switched off.
Insert the comb attachment as described below, and choose the desired cutting length with the selector.
Note: the cutting length selector does not turn while the appliance is operating.
Slide the ON/OFF switch upwards to turn the appliance on, and proceed with trimming, making sure to move
the appliance against the direction of growth of the hair, and to keep the cutting head as flat as possible on the
skin. Clean the comb attachment and the blades after each use, to avoid clogging and consequent damaging
of the appliance.
Mounting/removal of comb attachment
Make sure the appliance is switched off.
To mount the comb attachment, place the cutting length selector on "10", and fix the comb attachment to the
blades as shown in (FIG. B).
To remove the comb attachment, turn the appliance off, place the cutting length selector on "10", and gently pull
upwards.
Mounting/removal of blades
Make sure the appliance is switched off before proceeding with mounting or removal of blades.
To remove the blades, apply light pressure upwards with your thumb, right on the arrow found at the back of the
appliance (FIG.C).
To mount the blades, align the ribs on each side with the guides found on the appliance, and gently press
downwards until the blades are firmly fixed (FIG.C).
Cleaning and maintenance
Make sure that the appliance is switched off, and the power cable unplugged.
9