Blaupunkt BLP3360-002 Mode D'emploi page 14

13. Alarm button / Bluetooth / Disconnect
button
14. Mode change button
15. Power ON/OFF/Clock
16. MIC
Mode Selection
Press and hold POWER 1 sec. to power on the speaker. Press M to switch modes. Modes
include: Pairing Mode, USB Drive, TF Card, FM Radio and Auxiliary connection.
Note: Related modes will be skipped if USB drive, TF card or auxiliary cable connection is not
detected.
Bluetooth pairing
Power on the speaker. Pairing Mode is automatically entered. On your Bluetooth device, find
"BLP3360" under your Bluetooth settings (Input"0000"if password is required). A successful
connection via Bluetooth will be followed by an audible notification. Music from the device will be
played from the speaker.
Wireless speaker phone call
The Speaker phone call function is enabled when your device is connected via Bluetooth. Press
the Play/Pause knob to answer a call. Press the button again to end the call. To decline a call
without answering, press and hold the button Play/Pause for 3 seconds.
USB Drive
Insert an USB drive into the speaker's USB port to enter USB Drive mode or press the button M
repeatedly until voice prompt "USB Drive" is played. The speaker will play music from the USB
drive automatically.
Press the button < or > to skip tracks.
Note:
The speaker will switch to other mode automatically if no music is found in the USB drive.
The speaker does not read USB drive with memory over 32GB.
TF Card
Insert a TF card into the speaker's TF card slot to enter TF Card mode or press the button M
repeatedly until voice prompt "TF Card" is played. The speaker will play music from the card
automatically. Press the button < or > to skip tracks.
Note: The speaker does not read TF card with memory over 32GB.
FM Radio
Enter the FM Radio Mode by pressing the button M repeatedly until the voice prompt "FM Radio"
is played.
17. Next
18. Volume knob / Play/Pause button
19. Clock button
20. Previous
Operation