User Manual
CLEANING THE OUTSIDE
CLEANING THE BODY
COOLING DUCT
RECYCLING /
DISPOSAL
INSTRUCTIONS
8
APPENDIX C ‐ MAINTENANCE
Use household neutral detergent to clean the surface of the body and keep
it dry (the rubber cushion within the upper cover is set with a specific
direction; please do not remove it on your own).
The interior of the stainless steel tank is smooth. Never use abrasive
cleaners on your distiller. After each cycle rinse the inside of the boiling
chamber with clean water. To remove heavy deposits, use the distiller
cleaner as follows:
1. Pour hot water into the stainless steel
chamber until it covers the deposits.
2. Pour one to four spoonfuls of cleaner
(based on the amount of deposits) into
the tank.
3. Leave the upper cover off, plug in the
main power plug, and turn on the power
reset to heat the stainless steel tank
until boiling.
4. Discard the water fifteen to twenty
minutes later, then wash the interior
with clean water.
5. Repeat the process until the chamber is
clean.
6. Small amounts of residue are harmless,
and you can continue to use it safely.
If the condensing coil is clogged with dust, the
efficiency of distillation may be affected. To
clean the condensing coil, remove all three
screws from the underside of the cover. Use a
tooth brush or a vacuum cleaner to remove
the accumulated dust.
"T
"
AKE CARE
DO NOT IMMERSE THE MOTOR IN THE WATER WHEN
YOU ARE CLEANING THE COVER
REGULARLY ADD A LITTLE OIL ON THE MOTOR SHAFT TO HELP
MAINTAIN THE MOTOR IN GOOD WORDING ORDER
The distiller is mainly built from fiber‐reinforced polymers, metals and
electronic components. In case of disposal:
-
Separate the various components according to the materials they are
made of.
-
Drop the sterilizer with a company specialized on recycling these
products.
-
Do not abandon the sterilizer in unsecured places.
-
Always refer to current/applicable laws in the country of use.
Residue
cleaner
. W
E RECOMMEND YOU
.
Stillo