Assembly; Installing The Vacuum Bag; Packing List; Installing The Vacuum Tubes - Green Machine GM09000 Manuel D'utilisation

 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-332-1631 for assistance.

PACKING LIST

Blower
Upper Blower Tube
Sweeper Nozzle
Upper and Lower Vacuum Tubes
Vacuum Tube Screws (2)
Vacuum Bag
Vacuum Bag Adaptor
2-Cycle Engine Lubricant
Operator's Manual
NOTE: Read and remove all hang tags and store with your
Operator's Manual.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of the product
with damaged or missing parts could result in possible
serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.

ASSEMBLING THE BLOWER TUBES

See Figures 3 - 4.
 Align raised tabs on blower housing outlet to the slots on
upper blower tube; slide together and tighten securely by
twisting. Check tightness after initial use and retighten if
needed.
 Attach sweeper nozzle to upper blower tube by aligning
raised tabs on upper blower tube; slide together and
tighten securely by twisting. Check tightness after initial
use and retighten if needed.
 To remove the tubes, rotate the tubes to unlock them and
remove from the blower housing outlet.
All manuals and user guides at all-guides.com

ASSEMBLY

INSTALLING THE VACUUM BAG

See Figures 5 - 6.
 Remove the nozzle and upper blower tube from the
 Unzip the vacuum bag and push the vacuum bag adaptor
 Align the raised slots on the vacuum bag adaptor with the
 Rotate the vacuum bag until the shoulder strap is upright.
 Make sure the vacuum bag is zipped and closed before

INSTALLING THE VACUUM TUBES

See Figures 7 - 8.
To install the vacuum tubes:
 Secure the upper and lower vacuum tubes together by
 Tap tube assembly on ground until the screw holes in
 Depress door tab using a flathead screwdriver and open
 Align screw mounts on vacuum opening with screws on
 Turning clockwise, tighten screws on upper vacuum tube
To remove the vacuum tubes:
 Loosen screws of the upper vacuum tube by turning
 Remove the vacuum tube assembly from the blower
 Close the vacuum inlet cover door securely.
7 - English
blower by twisting and removing from blower housing
outlet.
through the opening opposite the zipper as shown. The
wider end of the adaptor will remain on the inside of the
vacuum bag when installed properly.
raised locking tabs on the blower housing outlet. Push
the vacuum bag adaptor onto the housing and twist to
lock into place.
starting the unit.
WARNING:
Contact with rotating impeller blades could result in seri-
ous personal injury. Always stop the engine and ensure
impeller blades have stopped rotating before opening
the vacuum door or installing/changing tubes. Do not put
hands or any other object into the vacuum tubes while
they are installed on the unit.
aligning the raised locking tabs with the raised slots.
lower tube are in the raised slot of the upper tube. Secure
with supplied screws.
vacuum inlet door.
vacuum tube assembly.
to secure to blower housing.
counterclockwise.
housing.