RAB Design AWLS-LED Serie Instructions D'installation

AWLS-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
•
Proper grounding is required to ensure personal safety.
•
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
•
Do not use this equipment for anything other than its intended purpose.
•
Servicing this equipment should be performed by qualified service personnel.
•
Save these instructions.
•
MIN 75 °C SUPPLY CONDUCTOR
INSTALLATION
- Loosen adjustable head with supplied Allen key and move head to 90
degree position.
- Remove the exposed screws and separate the back box from the luminaire.
- Prepare the backbox for installation by drilling mounting holes where
needed and installing the EVA gasket.
- Install back box to the wall. Seal two sides, top and the screw holes of the
back box using silicone.
- Install certified weatherproof electrical conduits or cable glands.
- Hook luminaire on the back box using the hinges.
- Make electrical connections as per the wiring diagram.
- Close the Luminaire & secure with screws.
- Adjust the head at desired angle & lock it in place with Allen key.
RAB Design Lighting inc.
READ, UNDERSTAND
before installing the equipment.
Dec 2020
FOLLOW
, and these instructions
Page 1 of 2