Electrical Safety - Dimas TS350E-02 Manuel D'utilisation Et D'entretien

Fitting the disc
6
(B) (SEE FIG 9)
The disc locking nut has a left-hand
thread.
!
If the machine is fitted with a brake
motor, do not use the quick-tighte-
ning nut.
(SEE FIG 11)
Take care about the direction of rota-
!
tion which is shown by an arrow on
one of the faces.
Make sure the contact faces of
flanges, of blade and the axle are
clean.
7 Electrical connection

ELECTRICAL SAFETY :

- The RCCB must be used correctly,
including testing it regularly. For
tools supplied with an integral
RCCB in the cable or in the mains
plug, if the cable or plug has been
damaged, repairs must be carried
out by the manufacturer, one of his
agents or by a qualified repair work-
shop to avoid any risks resulting
from errors.
=
?
- Three-phase motor
22
(A)
(SEE FIG 10)
(1) (2)
(B)
(A) (SEE FIG 13)
8 Starting up
Always pay extreme care and atten-
tion to the preparation of the machine
before starting up
Remove all adjustment tools and
wrenches from floor and machine
Always keep blade guard in place
As each machine is fitted with a self priming
pump, the water is sprayed onto the disc as
soon as the machine starts.
Ensure that the water supply is abundant,
when cutting wet.
The protective case and the motor mounting
fitted with a deflector blade provide perfect
distribution of the spray.
STOP
phase motor protected by a built-in thermal cir-
cuit breaker.