Assembly Instructions - Ojmar NLX1 Manuel D'installation

Masquer les pouces Voir aussi pour NLX1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.2. ASSEMBLY INSTRUCTIONS

The NLX1 lock is attached to the locker door with four screws.
• Recommended screws:
o Conglomerate doors: Pan head wood screw 4.5 x 35 DIN 7996 (depending on the thickness of the door)
o Phenolic or metal doors: Pan head screw M5 x 25 DIN 7985 (depending on the thickness of the door)
• The maximum tightening torque to apply to the tightening of each screw or coach nut will be 150 Ncm.
• The diameter of the central hole should be 23 mm (+1/0 mm). Bevelling the hole on the inner area of the door is
recommended.
During installation, ensure that the lock does not collide with the locker body with the door open (see design 1.2).
The dimensions and location of the anchorage points are shown in the following designs (the dimensions depend on the design
of the locker and the type of striking plate used with the lock:
NLX1_LOCK INSTALLATION AND ASSEMBLY
OJMAR 2

Publicité

Table des Matières
loading

Produits Connexes pour Ojmar NLX1

Table des Matières