Nlx1 Lock Installation And Assembly; Lock Directions - Ojmar NLX1 Manuel D'installation

1. NLX1 LOCK INSTALLATION AND ASSEMBLY

The NLX1 lock can be installed on doors with thicknesses between 9 mm and 20 mm.
The assembly of the lock in the locker door must be correctly carried out to ensure the correct operation of the lock.
The positioning of the holes, the distance of the lock on the locker body and the distance of the lock to the locking device, as
shown in designs 1.2 and 1.3, must be correctly measured to prevent any subsequent problems when locking.

1.1. LOCK DIRECTIONS

Lock installation must be carried out with screws in four drilled holes.
Lock assembly depending on if it is right handed or left handed is as follows.
NLX1_LOCK INSTALLATION AND ASSEMBLY
Design 1.1 - Diagram of right and left locks
OJMAR 1