Fronius Power Relay Card Instructions De Service page 8

Characteristics of If a circuit is to be connected to the rely contacts of the Fronius Power Relay Card, the cir-
a Circuit to be cuit must correspond to the following data:
Connected -
-
-
-
Inserting and
1
Connecting the
Fronius Power
Relay Card to the
Inverter
2
3
4
6
Max. DC voltage ..... 50 V DC
Max. DC current ........ 1 A DC
Max. AC voltage .... 250 V AC
Max. AC current ........ 4 A AC
Insert and secure the Fronius Power Relay Card in the inverter as per the inverter op-
erating instructions.
NOTE! When laying cabling, make sure that the cable does not touch any elec-
tronic components or edges. Lay the cable in a large loop.
Insert the cable into the inverter
4
1
3
4
5
Secure the cable using the strain-relief device or cable ties in the inverter
-
-
-
-
2
6
-
Insert the cable through the long slot in
the connecting plate of the Fronius
Power Relay Card
Connect the cable to the Fronius Pow-
er Relay Card
Insert the cable in the strain-relief de-
vice
Insert the strain-relief device and cable
through the long slot on the Fronius
Power Relay Card
Secure the cable using cable ties near
the relay contacts