Trico Streamliner DC 30 Mode D'emploi page 8

Lubricants
The standard lubricant range suitable for Streamliner DC includes modern high quality
lubricants tested and modified for the special requirements of grease and oil dispensers.
Datasheets are available online for all lubricants (www.tricocorp.com). Please refer to
these datasheets for the instructions/safety regulations of the grease/oil manufacturers.
Grease Type
Mobilith XHP 222
Exxon Unirex EP 2
Mobilith SHC 100
Mobil FM 222
Mobilith SHC 220
Mobilith SHC PM 460
Mobil Polyrex EM
Streamliner DC can also be delivered filled with other lubricants or as an empty unit.
Ask for advice. The operation of Streamliner DC with oils of different viscosities is also
Troubleshooting
Fault
– no grease output
– insufficient output
– excessive output
For other malfunctions contact Trico Corp at 262.261.9336.
The information provided reflects the manufacturer's current level of development and
understanding. Subject to change. The products are subject to strict manufacturing con-
trols and meet internal works specifications. As a result of the wide range of conditions
and areas of application possible in each case, no guarantee can be provided for effec-
tiveness or success in each individual instance. No responsibility is accepted for damage
or malfunctions caused by incorrect use or improper work on or with the lubricator.
Possible cause
– seal not cut off/closing nipple
still in place
– not switched on
– grease lines blocked
– gas generator loose
– dispensing time too long
– ambient temperature too low
– grease lines blocked/too
narrow
– short-term extreme low
temperatures, piston moves
backwards
– high counter pressure
– dispensing time too short
NLGI Thickener Type
2
Lithium Complex
2
Lithium Complex
2
Lithium Complex
2
Aluminum Complex
2
Lithium Complex
1.5
Lithium Complex
2
Polyurea
Remedy
– open/remove
– switch on
– clear lines with grease gun
– tighten with 2 Nm
– set to lower number
– correct setting according to
table, page 16
– clean, allow for free flow of
grease
– none
– clear grease lines, check
installation
– set to higher number
8