Function And Location Of The Controls; Scan Mode - Alan 78PLUS MULTI B Mode D'emploi

FUNCTION AND LOCATION OF THE CONTROLS

1
ALAN 78 PLUS
MULTI
EMG
CHANNEL
1. Channel selector
2. Multifunction backlighted display. It shows:
A
B
A. Channel selected number
B. The received signal strength and the power of the transmitting signal
C. AM/FM mode
D. RX/TX:TX=transmit mode; RX=receive mode
E. SCAN mode
F. EMG mode
G. Frequency band selected.
H. LOW: displayed when the radio transmits in low power (this mode is possible
with some frequency bands only – see the Frequency band chart).
I. LOCK: microphone (UP/DOWN buttons) lock enabled.
3. "EMG" button: Emergency channel. By pressing it, you will be automatically posi-
tioned on CH 9 (emergency channel). The display will show "EMG". It will not be
possibile to change accidentally the channel.
4. 5. "Q.UP/Q.DOWN" buttons: To skip 10 channels UP (Q. UP) or 10 channels DOWN
(Q.DOWN).
6. "AM/FM"(LCR) button: To select AM or FM mode. If you switch on the unit and
push "AM/FM"(LCR) and "SCAN" at the same time, you will select the operating
band, which will be visualised on the display.
If you select a frequency band operating in FM mode only, this button enables the
LCR function (Last Channel Recall).
2
88
FM SCAN
CH
AM
LOW
SIG
RX
+30
9
5
3
1
TX
0.5
1 2 3 4 PWR
LOCK EMG
Q.UP Q.DOWN AM/FM SCAN
LCR
3 4 5 6 7
C H
88
FM
CH SCAN
AM LOW
9
5
3
1
0.5
1 2 3
LOCK EMG
I F
2
8 9
SQUELCH ON/OFF VOL
ON/OFF
E
G
SIG
+30 RX
D
TX
4 PWR
10
MIC