Salton Steam Fast SF-450 Mode D'emploi page 14

SF-450 Booklet V2 11/9/01 4:11 PM
ASSEMBLY
Hanger Rod
Place the appliance on a steady surface. The bottom rod
is threaded on one end. Screw the two larger rods
together. Insert the bottom of the rod into the holder
on the unit base and screw the set screw until tight.
NOTE: Do not over tighten. Screw the top rod, with hook,
into the top of the large rod.
Steamer Hose
Screw the end of the Steamer Hose with the knurled knob
onto the threaded pipe on the top of the steamer unit.
NOTE: Do not use excessive force in tightening
(See Ill. 6A)
the knob. Tighten by hand until it no longer turns. Hang
the Nozzle from the Hanger Rod.
the Water Container, be certain that the Steamer's Drain
Plug is properly installed and tightened to prevent leaking.
Water Container
Turn the Water Container upside down and inspect to see the valve and
spring assembly are functioning. Place the Container in the reservoir.
Ensure that it is seated securely.
HOW TO USE
1. Ensure that the On/Off Switch is in the 'Off' position. Set the unit on the
floor and remove the Water Container. Check the inside of the Container
for sediment. Turn the Container upside down and push the valve open
and allow to close two or three times to insure it is functioning smoothly.
If the Container has been stored with water inside, it may be necessary to
remove the water and clean the Container. Follow
the steps in the Care and Cleaning section.
2. Remove the Water Container by the handle and turn
upside down.
(Ill. 7)
of the Container and pour cold water into the
opening or hold under a source of running water
until the Container is filled to the desired level.
Page 14
(See Ill. 5)
Prior to filling
(See Ill. 6B)
Unscrew the valve in the center
Ill. 5
Ill. 6A
Ill. 6B
Ill. 7
5