Standard FlexScape 65592 Instructions D'installation

LED OUTDOOR FLOOD LIGHT
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS BEFORE THE INSTALLATION.
CAUTION: This product use an input 100-277 VAC driver, the actual working voltage is dependent on the input voltage of
the photocell that is installed on the product (photocell is optional). An internal power-factor-corrected switch-mode supply
allows it to be used from any nominal 100V-277 V, 60 Hz AC supply without any variation in light output.
NOTE: SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING: Risk of fire or electric shock. The installation should be performed only by a qualified electrician in accordance
with the National Electrical Code and relevant local codes. This product must be installed in full accordance with applicable
electrical and building codes. This fixture is for outdoor use and should not be used in areas with limited ventilation or high
ambient temperatures.
WARNING - TO AVOID ELECTRIC SHOCK:
• Be certain electrical power is OFF before and during installation and maintenance.
• Luminaire must be connected to a wiring system with an equipment-grounding conductor.
WARNING - TO AVOID EXPLOSION:
• Make sure the supply voltage is the same as the rated luminaire voltage.
• Do not install where marked operating temperatures exceed the ignition temperature of the hazardous atmosphere.
• Do not operate in ambient temperatures above those indicated on the luminaire.
• Keep lens tightly closed when in operation.
• For supply connections use wire rated for at least 90°C.
PRODUCT DIMENSIONS