Cleaning And Maintenace - Giubra Professional ZEROCUT STRONG Mode D'emploi Original

EN
• Do not use the device on animals
• Do not press the blade against your skin. Do not subject the
outer blade to excessive pressure.
• Only use the hair clipper for its intended use.
The non-observance of this advice may result in lesions or
damage to the blades.
FIXED-LENGTH FUNTION:
Use of clipper comb: cropped hair and hair trim feature:
(3,6,9,12mm) four lenghts adjustamet. Control the hair length.
1. To determine the length of haircut.
2. To select the appropriate limit comb.
Mount the comb:
1. Align the comb with the blade edge.
2. Slightly forward push to mount it.
Disassemble the comb:
Just pull hard the comb.
CLEANING AND MAINTENANCE
At the end of each cut it is advisable to clean the blades of hair
residues and proceed with lubrication in order to keep the ap-
pliance in good working order.
Proceed as follows:
• make sure that the switch is in the "0" position (appliance off);
• eliminate hair deposits using the brush supplied;
• remove the blades by unscrewing the two fixing screws. The
blade block can be rinsed under the tap;
• pour one or two drops of oil on the blades;
• reposition the blades by tightening the two fixing screws;
• start the appliance for a few moments to allow the oil to expand
over the entire surface of the blades;
• remove any excess oil with absorbent paper with the appliance
off.
2343-booklet.indd 19 2343-booklet.indd 19
19
12/11/20 12:52 12/11/20 12:52