Original Instrunctions For Use; How To Charge The Battery; How To Use The Appliance - Giubra Professional ZEROCUT STRONG Mode D'emploi Original

EN

HOW TO CHARGE THE BATTERY

The device operates through a rechargeable battery:
• Insert the charger plug into the appropriate input located at
the base of the device.
• Check that the on / off switch is in the "0" position (appliance
off).
• Plug the charger into the mains. The power indicator will turn
blue to indicate it is charging.
The time required for a full charge is 3 hours.
Note: if the led light power does not turn on, check that you have
connected the charger correctly.
WARNING!
• For the charging operation, use only the supplied battery char-
ger.
• Do not recharge the battery when temperatures are below 0 °
C or above 40 ° C.
• Do not recharge the battery in direct sunlight or near heat
sources.
• Do not recharge the battery for more than 48 consecutive
hours.
• During the charging phase, the hair clipper may be slightly he-
ated.
Suggestions to prolong the duration of rechargeable
batteries
After having charged the device the first time, we suggest that
you use it until the battery is completely empty.
Keep using the device until the motor stop during use.
Then recharge the battery. Repeat this operation at least twice
a year.
The rechargeable battery cannot be replaced. At the end of
its life cycle it must not be dispersed in the environment but
must be disposed of according to the environmental regula-
tions in force in your place of residence.

HOW TO USE THE APPLIANCE

The device has been designed to cut dry hair only. Never use
it on wet hair.
- Check that the appliance is clean and that the blades are pro-
perly lubricated and in perfect operating conditions.
- Make sure that the appliance is off and adjust the desired
length of the cut (see paragraph "Fixed-length Function").
- Turn the switch to position "I" (appliance on) to start the ap-
pliance and proceed with cutting.
- At the end of use, bring the switch to position "0" (appliance off)
and proceed with the cleaning and lubrication of the blades (see
specific paragraph).
2343-booklet.indd 18 2343-booklet.indd 18
ORIGINAL INSTRUCTIONS FOR USE
18
12/11/20 12:52 12/11/20 12:52