How To Replace The Vacuum Belt And The Headlight Bulb - Simplicity S20EZM Manuel Du Propriétaire

HOW TO REPLACE THE VACUUM BELT AND
HEADLIGHT BULB
CAUTION: Unplug the vacuum cleaner�
How to Remove the Bottom Plate
1� Place the vacuum in the lowest position by stepping
on the handle release pedal (see "How to Adjust the
Handle" on page 5)� Turn the vacuum over on a flat
surface, exposing the bottom plate�
2� Remove the five screws holding the bottom plate in
place (Fig� 1)�
3� Remove the bottom plate�
How to Replace the Belt
1� Turn the vacuum over and remove the bottom plate
as described above�
2� Lift out the brushroll and remove the belt (Fig� 2)�
3� Loop a new belt around the drive shaft (Fig� 3)
and the raised ring between the bristles on the
brushroll (Fig� 4)�
4� Pull the brushroll forward (against the pull of the
belt) and reinsert the ends back into the nozzle
(Fig� 5) making sure to line up the end opposite the
belt so the flat edges slide down properly�
5� Turn the brushroll by hand, making sure the belt is
not twisted and all rotating parts move smoothly�
6� Replace the bottom plate and the five screws�
How to Replace the Bulb
1� Place the vacuum in the lowest position by stepping
on the handle release pedal (see "How to Adjust the
Handle" on page 5)�
2� Remove the two screws from the headlight lens (Fig� 6)�
3� Remove the lens and replace the bulb (Fig� 7)�
4� Replace the headlight lens and the two screws�
8
Fig� 6
Screw
Screw
points
Screw
points
Screw
points
Screw
points
points
Fig� 1
Fig� 2
Drive
Drive
shaft
Drive
shaft
Drive
shaft
Drive
shaft
shaft
Fig� 3
Fig� 4
Fig� 5
Fig� 7