Publicité
Les langues disponibles
Les langues disponibles
SCAN & WATCH
HOW IT WORKS
qr.ninjakitchen.com/
creami-ca
Perfectly personalized ice cream
PREP: 5 minutes | FREEZE: 24 hours | PROGRAM TIME: 1
INGREDIENTS
1 tablespoon (18 g) cream cheese
70 g granulated sugar
180 ml heavy cream
PICK YOUR FLAVOR
Cocoa powder
Vanilla extract
MAKE IT DAIRY-FREE Use vegan cream cheese for cream cheese, unsweetened coconut cream
for heavy cream, and unsweetened oat milk for milk. Whisk the coconut cream until smooth,
then add the remaining ingredients.
Microwave the cream
Slowly mix in heavy
cheese for 10 seconds.
cream and milk until
sugar is dissolved.
Add sugar and flavor,
then whisk the mixture
until it looks like frosting.
PICK YOUR MIX-INS TO ADD A PERSONAL TOUCH
/
cup of your favorite crushed candies, frozen fruits, chopped nuts,
1
4
chocolate pieces, and more.
With a spoon, create a 4 cm
wide hole that reaches the
bottom of the pint.
Add mix-ins to the hole in the
pint and process again using
the MIX-IN program.
1
/
minutes | MAKES: 4 servings
2
Flavoring, 1 teaspoon extract of your choice
OR 2 tablespoons of cocoa powder
240 ml whole milk
40 g of your favorite mix-ins (optional)
Mint extract
Almond extract
Fruit extract
Pour base into
Remove lid from
CREAMi™ Pint. Place
frozen pint.
lid on pint and freeze
Refer to next page for
for 24 hours.
Assembly & Process
instructions.
Select ICE CREAM.
Assembly & Process
1.
2.
Plug in unit first
Install
CREAMi™ Pint
The unit will NOT run
if the outer bowl is
Remove lid from pint and
installed before the
check that the ingredients
have not been frozen at
unit is plugged in.
an angle. Place the pint
containing the frozen
base in the outer bowl.
If programs will not illuminate, make sure the unit is properly assembled.
See the troubleshooting section of the safety instructions if install light is illuminated.
5.
Install outer bowl
Select program
After plugging in the unit, place
Press the power button,
the outer bowl on the base with the
then select the program
handle in the middle of the unit.
that suits your recipe.
Twist handle to the right to raise
the platform and lock the bowl in
place. You should hear a click.
8.
If adding mix-ins, use
Remove lid
a spoon to create a 4 cm
wide hole that reaches
Press the lid unlock
the bottom of the pint.
button and twist
Add chopped or broken
to remove lid.
mix-ins to the hole in the
pint and process again
using the MIX-IN program.
3.
4.
Install lid
Install
Creamerizer™
Position the tab of the
Paddle
lid just slightly to the
right of the outer bowl
Push the paddle
handle so the lines
into the underside of
on the lid and handle
the outer bowl lid.
align. Rotate the lid
clockwise to lock.
Bowl Release
Button
To remove the
outer bowl, hold
release button.
6.
7.
Remove bowl
When program ends, hold the
release button on the left of
the motor base and twist bowl
handle clockwise to remove.
OR
9.
If not adding mix-ins,
RE-SPIN can be used on
a crumbly or powdery
pint to make it creamy.
RE-SPIN is often needed
for very cold bases.
DO NOT RE-SPIN before
using MIX-IN program.
Publicité
