Bodet 927240 Mise En Service page 2

1
Fix the repeater in the area covered by
the transmitter. Under no circumstances
the transmitter should be directly fixed on
a metallic surface.
3
B
A
Connect the 230V (A) and block the
cable (B). Apply the power.
E
F
In "initialisation" mode, the LED (E) is
on. To switch it on, short-circuit the two
pins (F) for 3 seconds.
Specifications:
Indoor or outdoor use.
Power supply : 100-240 V 50-60 HZ
Nominal current : 50 mA
Power supply drawing: IT
Electrical insulation : Class II
Operating temperature : -10°C to +50°C
Protection index: IP54 and IK 07.
This system is compliant with :
RADIO NORM : EN 300-220-3
EMC norm for radio equipment : EN 301-489-3
Safety norm : EN 60950.
AFNOR Norm : NFS 87500.
2
The DHF repeater (ref.: 927240) enables to extend an area non covered by the
4
Status of the DHF repeater at the first start
up.
- Power DIP (D) in position MED (125W).
- Power setting LED (C) ON (125 mW)
- INIT mode yellow LED (E) blinks (waiting for
the initialization of the main transmitter),
- DHF transmission Red LED (G) OFF.
6
7a
C
D
You can adapt the transmission power
with two DIP switches (D). LED (C) allows
you to check your setting.
Set up of a DHF repeater
Transmitter
main DHF transmitter.
5
The DHF repeater must be
G
paired with the DHF transmitter in order to
- Check that the « Init » mode yellow LED blinks. If
not, set up again the repeater in « Initialization"
mode (part 6).
- Set up the main transmitter in "Init" mode.
- Once the signal of the main transmitter is
,
transmitted, the « Init » mode yellow LED is OFF
and the DHF transmission red LED is ON.
Leds
Dips
If some clocks are not synchronised, increase the
The DHF repeater has a horn (H). It can be
activated from the master clock Sigma to enable a
927240
B.P. 1
49340 TRÉMENTINES
FRANCE
Tél. : 02 41 71 72 00
Fax : 02 41 71 72 01
www.bodet.fr
Repeater
work properly:
Té moin
H
émis sion
0 0 0 1
1 0 1 1
125mW 500mW
OFF (0W) 25mW
transmission power.
localization of the DHF repeater.
7b