Injectors Replacement; Adjustment Of Minimum Level - Electrolux KGG64375K Notice D'utilisation

Make sure that the gas
supply pressure of the
appliance obeys the
recommended values. The
adjustable connection is
fixed to the comprehensive
ramp by means of a
threaded nut G 1/2". Screw
the parts without force,
adjust the connection in the
necessary direction and
tighten everything.
A B C
A. End of shaft with nut
B. Washer supplied with the appliance
C. Elbow supplied with the appliance
WARNING!
It is important to install the
elbow correctly. Make sure
that the shoulder is on the
end of the thread. Then
install it on the hob
connecting pipe. Incorrect
assembly may cause a gas
leakage.
Liquid gas
Use the rubber pipe holder for liquid gas.
Always engage the gasket. Then
continue with the gas connection.
The flexible pipe is prepared for apply
when:
• it can not get hot more than room
temperature, higher than 30°C;
• it is no longer than 1500 mm;
• it shows no throttles;
• it is not subject to traction or torsion;
• it does not get in touch with cutting
edges or corners;
• it can be easily examined in order to
make sure its condition.
The control of preservation of the flexible
pipe consists in checking that:
• it does not show cracks, cuts, marks
• the material is not hardened, but
• the fastening clamps are not rusted;
• expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
1/2

3.3 Injectors replacement

1. Remove the pan supports.
2. Remove the caps and crowns of the
1/2
3. With a socket spanner 7 remove the
4. Assemble the parts, follow the same
5. Attach the label with the new type of
If the supply gas pressure is changeable
or different from the necessary pressure,
you must fit an applicable pressure
adjuster on the gas supply pipe.
3.4 Adjustment of minimum
level
To adjust the minimum level of the
burners:
1. Light the burner.
2. Turn the knob on the minimum
3. Remove the knob and using thin
of burnings on the two ends and on its
full length;
shows its correct elasticity;
WARNING!
When installation is
complete, make sure that
the seal of each pipe fitting
is correct. Use a soapy
solution, not a flame!
burner.
injectors and replace them with the
ones which are necessary for the
type of gas you use (see table in
"Technical Data" chapter).
procedure backwards.
gas supply near the gas supply pipe.
You can find this label in the package
supplied with the appliance.
WARNING!
Information for authorised
installer only.
position.
screwdriver lift up and remove the
plastic magnet holder.
ENGLISH 9