Sartorius YFP02CWS Mode D'emploi page 3

Model-specific data and dimensions:
Designation
Width (mm)
Length (mm)
Countersunk screws,
M16+30
(size 10 Allen key)
Countersunk screws,
M8+16
(size 5 Allen key)
It is not necessary to remove the screws if the platform is equipped with a lift deck
mechanism (Option T8).
YFP02CWS Fastening Kit
! Note:
The fastening kit is for use only with Combics series
weighing platforms sizes II to WR manufactured in
2006 or later. If loads are driven onto the weighing
platform from two directions, two fastening kits
must be installed.
§ Carefully unpack the fastening kit
Equipment supplied:
– 2+ fastening plates
– 2 screws, size M12+50 mm
– 2 washers
– 2 hexagonal nuts, size M12
– 2 hexagonal nuts, size M10
!
Note:
The Combics weighing platform referred to in
these instructions is already mounted in the pit
installation frame.
§ Remove the load plate from the Combics weighing
platform and remove the countersunk screws.
II LL NL
800 1000 1000
800 1000 1250
4 4 4
2
NN RN RR
1250 1250 1500
1250 1500 1500
4 4 4
4 6 6
WR
1500
2000
4
8
3