Jacob Jensen Doorbell II Cordless Manuel D'utilisation page 13

Reset
The RESET key in the battery compartment is used for resetting the system. If there
is any malfunction (such as no sound from the chime) try pressing the RESET button
to make the unit ready to receive or transmit a signal again.
Mounting
To mount the chime:
The chime is designed to be
free standing, in order for
it to be placed and moved
as needed. Can also be wall-
mounted by means of the
enclosed fitting.
To mount the bell push:
The bell push is easily
mounted by means of the
enclosed safety fitting,
screws and plugs. When
the mounting plate is fixed,
slide down the bell push
until a "click" is heard.
For changing the battery,
release the bottom lock by
pressing the hook towards
you (use a small and flat screwdriver to handle the lock). Remain with the lock in
released position while sliding the bell push upwards and out. The bell push is not
to be mounted on metal door frames.
Note: The maximum working distance between the chime and the bell push is
80 metres. Metal structures or reinforced PVC doors or doorframes may affect
transmission or reduce the transmission range.
Specifications
Operating temperature – chime
Operating temperature – bell push
RF Transmission Frequency
Batteries - chime
Batteries - bell push
Dimensions - chime
Weight - chime
Dimensions – bell push
Weight – bell push
Maintenance
The following guidelines will help you care for your JACOB JENSEN
so you can enjoy using it for many years.
· Placement of this product on wood surfaces with certain types of finishes, such as
clear varnish, may result in damage to the finish. We shall not be responsible for
any damage to wood surfaces from contact with this product.
· Always keep the chime dry. If you spill liquid over it, dry it immediately with a soft,
lint-free cloth.
· Do not clean the unit with abrasive or corrosive materials.
· Use and store the units only under normal temperatures. Temperature extremes
can shorten the life of electronic components, damage batteries and distort or
melt plastic parts.
· Handle the units gently and with care. If they are dropped, circuit boards can be
damaged, resulting in malfunction.
· Keep the units free from dust and dirt to avoid the premature wear of parts.
· Use only fresh batteries of the required size and type. Always remove old or weak
batteries as they might leak chemicals that will damage the product.
: 5˚C to 50˚C (41˚F to 122˚F)
: -20˚C to 60˚C (-4˚F to 140˚F)
: 433 MHz
: 3 x UM-3 (AA) batteries –
Energizer E91 recommended for
approx. 12 months battery life
: 2 x UM-4 (AAA) batteries
: 178 x 122 x 60 mm
: 460 g
: 106.5 x 36 x 28 mm
: 75 g
Doorbell II unit
TM
· Modifying or tampering with the internal components of the chime or the bell
push may cause unnecessary damage and will invalidate the warranty.
· The units contain no user-serviceable parts.
· Do not dispose this product as unsorted municipal waste. Collection of such
waste separately for special treatment is necessary.
· The contents of this manual may not be reproduced without the permission of
the manufacturer.
If the Doorbell does not work:
1. Check that the volume is not turned OFF in the battery compartment of the chime.
2. Check the batteries by activating the bell push. The lights on both the chime and
the bell push should light up (ensure the light is not turned OFF on the chime).
Replace the batteries if the unit is not lighting up.
3. Reset by pressing the RESET key in the battery compartments.
4. Check that the units have identical codes, and if not adjust them.
5. Check that the chime and the bell push are not too far apart.
6. Other products, using the same frequency, or materials may interfere with the
signal. Remove the object causing the interference or find another position for
the chime, where a clear signal can be obtained.
Environmental concerns and disposal
Electric and electronic appliances and enclosed batteries contain materials,
components and substances that can be damaging to people's health and to the
environment, if the waste is not disposed of correctly.
Electric and electronic appliances and batteries are marked with a crossed-out
wheelie bin symbol as illustrated below. It indicates that electric and electronic
appliances and batteries are banned from being disposed of as general household
waste, and have to be collected separately.
Please ask you dealer about current means of disposal.
- The technical specifications for this product and the contents of this manual are
subject to change without notice.
- The manufacturer and its suppliers accept no liability whatsoever for any damage,
expenses, loss of profits or any other damage incurred as a result of using this
product.
13