Best WC45 Mode D'emploi page 11

EXTERNAL BLOWER ELECTRICAL CONNECTIONS
Blower connection at hood:
1. Run 2-wire plus ground power cable fromthe Exterior or In-Line Blower to the hood wiring
box marked "motor connection". (Fig.8).
2. Remove the cover from the wiring box and remove one knockout.
3. Feed 6" of cable through the knockout opening and secure the cable to the wiring box with
an appropriate connector.
4. Make electrical connections at the hood.Connect white-to-white, red-to-black and green-
to-ground.
5. Replace the wiring box cover and screws, make sure wires are not pinched between the
cover and box.
Exterior or In-line blower connection:
1. Make electrical connections at the exterioror in-line blower (see instructions providedwith
the exterior or in-line blower).
Power connection at hood:
1. Plug the power cord into the electrical wall receptacle.
BOX MARKED
"MOTOR
CONNECTION"
BLOWER CONNECTION AT HOOD
- 11 -
EXTERIOR OR
IN-LINE BLOWER
CONNECT:
WHITE-TO-WHITE,
RED-TO-BLACK,
GREEN-TO-GROUND.
FIG.8