GE SPSD157JWW Instructions D'installation page 3

LEVEL THE WASHER OR DRYER
4
A Locate the 4 legs from the parts package
and install.
Stand the washer or dryer upright. Move it
B
close to its final location.
Make sure that the washer or dryer is level
C
by placing a spirit level on top. Check side
to side and front to back.
Use an open
D
ended wrench to
adjust the legs
in and out.
Tighten the lock
nut against the
bottom of
the pedestal.
NOTE:
• To minimize vibration, the locking nuts must
be tight.
• To reduce vibration, ensure that all four rubber
leveling legs are firmly touching the floor. Push
and pull on the back right and then the back
left of your washer or dryer.
REINSTALL THE DRAWER
5
Check to
A
be sure the
slides are
closed.
Slide the
B
drawer
Drawer
into the
divider
opening.
Align the
drawer
supports to the
slides on each
side.
Reinstall the original screws into each drawer
C
slide. Tighten both screws.
Open the drawer fully. Slide drawer divider
D
into slots in the center of the drawer. The
drawer should slide smoothly when you push
it closed.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Installation Instructions
3
REMOVE SHIPPING SCREWS
6
Remove the 4 shipping screws on the back side
of the unit.
FINALIZE THE INSTALLATION
7
Refer to the washer or dryer Installation Instructions
to complete the installation.