Publicité
-Se han de utilizar los latiguillos nuevos suministradas con el aparato. Los latiguillos viejos no deben de
utilizarse.
- Asimismo Noken Design S.A. declina toda responsabilidad en caso de una instalación incorrecta.
Nota: -Revisar el material a su llegada, y si se advierte algún desperfecto reclamar de inmediato
al transportista.
-Verificar el producto, y el perfecto estado de sus componentes antes de realizar la instalación. Si
se advierte algún defecto, proceder a la reclamación antes de la instalación.
Advertencia: Es necesario, el acceso total a las partes no visibles de la bañera, con el fin de
poder realizar futuras tareas de mantenimiento.
-Noken Design baths are manufactured to the strictest standards to ensure quality performance and full
customer satisfaction at all times.
-Each and every one of our baths is assembled and tested before leaving the factory.
-All plumbing installation work should be effected in compliance with national regulations concerning
plumbing installations in buildings.
-The system must only be installed by qualified professionals.
-The installation should be in accordance with the wiring regulations in force at your country. Make
sure the circuit you are connecting to the whirltub, has been installed and protected to the installation
standards in force at your country.
-Noken Design S.A. declines all responsibility in the event of improper installation.
-This bathtub can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user maintenance shall not be made by children without
supervision.
-The maximum recommended water hardness for the range of baths is 18ºTH (French degree of
hardness) / 13ºe (English degree of hardness).
-The baths are not designed to be used for seaweed, mud or seawater treatments, etc.
-There is an increased risk of falls when the surface of most baths is wet and therefore slippery. This is
particularly true when soap, shampoo, bath oils and other similar products are used. Users of baths must
be aware of this fact.
- Noken Design baths are manufactured to the strictest standards to ensure quality performance and full
customer satisfaction at all times.
- Each and every one of our baths is assembled and tested before leaving the factory.
- All plumbing installation work should be effected in compliance with national regulations concerning
plumbing installations in buildings.
- The bathtub must only be installed by trained plumbing engineers following strictly the manual guideli-
nes.
- The installation should be in accordance with the wiring regulations in force at your country. Make
sure the circuit you are connecting to the whirltub, has been installed and protected to the installation
standards in force at your country.
-Disconnecting means must be incorporated into the fixed installation in accordance with the installation
regulations
-If the power cord cable is damaged, it must be replaced by the Noken after-sales service or by similar
qualified person in order to avoid a danger
- The parts that contain active parts, except those supplied with very low safety voltage that does not
exceed 12 V, are inaccessible for a person inside the bathtub.
-The devices that are grounded must be permanently connected to a fixed electrical canalization
3
Publicité
