Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PAT TESTING.
When used in a workplace, this product must be safety-tested yearly by a
qualified electrician (PAT Tested) in order to comply with the Electricity at Work
Regulations.
We recommend that it is PAT tested regularly when used in a domestic
environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least
once every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is mandatory
for new buildings).
OPERATION
To fill the water tank:
Remove the nozzle from the vapour outlet vent.
Remove the water tank (by lifting the handle labelled "humidifier") vertically
upwards.
Turn the tank upside down, and unscrew the lid.
Fill the tank with cold water.
Replace the lid, making sure that it is screwed down tightly.
Replace the tank in the humidifier
Replace the nozzle on the outlet vent.
To operate:
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead is rated at 3 Amps or
more, and that it is fully unwound.
To operate the unit, press the ON/OFF button. (Press it again to switch the unit
off)
Press the MODE button to select the moisture output: Mode I is on constantly,
Mode II is on for 1 minute and off for 1 minute, Mode III is on for 1 minute and off
for 3 minutes.
If the "EMPTY" indicator lights, then fill the tank as above.
Unplug from the mains, empty the water tank and dry thoroughly, when not in
use.
Timer:
The humidifier can be set to switch off after a period of time up to 7 hours. Press
the TIMER button repeatedly until the required number of hours is shown on the
LEDs.
Page 3
Publicité
Table des Matières
