Thorough Cleaning - Uline 3M Mode D'emploi

IMPORTANT! Respirator components must be inspected prior to each use. A respirator with any damaged or
deteriorated components must be repaired or discarded.
IMPORTANT! Cleaned respirators should be stored away from contaminated areas when not in use.
QUICK CLEANING
1. Remove cartridges and/or filters.
2. Wipe the facepiece with:
• 3M respirator wipes (Uline model # S-19288)
• Uline respirator wipes (Uline model # S-21592)
PAGE 2 OF 6
MAINTENANCE

THOROUGH CLEANING

1. Remove cartridges and filters.
2. Clean face piece (excluding filters and cartridges)
by immersing in warm cleaning solution with water
temperature below 120˚F. Scrub with soft brush until
clean. Add neutral detergent if necessary.
NOTE: Do not use cleaners containing lanolin
or other oils.
3. Disinfect face piece by soaking in a solution
of quaternary ammonia disinfectant or sodium
hypochlorite (1 oz. household bleach in two gallons
of water or other disinfectant).
4. Rinse in fresh, warm water and air dry in
non-contaminated atmosphere.
1-800-295-5510
uline.com
0222 IH-1081