Prem-I-Air Elite EH1464 Mode D'emploi page 4

Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead is rated at 10 Amps
or more, and that it is fully unwound.
Switch the unit on at the mains socket.
Press the button on the remote control to operate the heater.
Press the ADJUSTOR button once, twice or three times to select cool air, low
heat or high heat.
Using the + and ˜ buttons, select the desired room temperature. The selected
temperature is displayed in the 2-digit LED display on the front panel in degrees
Celsius.
Press the SWING button to select louvre oscillation. Press SWING again to
switch off louvre oscillation.
The TIMER can be used to turn the heater off after it has operated for a set time.
The time can be set in half-hour intervals from ½ hour to 7½ hour, by repeatedly
pressing he TIMER button. The LEDs on the front panel indicate the time that has
been set (add up the times shown next to the indicators that are illuminated).
Some control functions are avialable by pressing the buttons on the front panel of
the heater.
Press the button to switch the heater on.
Press once for cool air, twice for low heat and three times for high heat, four
times for high heat with louvre oscillation. Press the
off.
Do not touch the air output grille when the heater is in operation, because it will
be hot and may cause burns.
Unplug the heater from the mains when not in use.
At time of going to press, the average cost of electricity is £0.12 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill.
At this cost, the EH1464 will cost £0.24 per hour to run with the thermostat set to
its maximum.
If the thermostat is used to regulate the temperature the operating costs will be
lower, depending on the room temperature.
OPERATION
OPERATING COSTS
4
button again to switch