weBoost Drive 4G-X Mode D'emploi page 6

Screw the NMO antenna assembly (E) into
place on top of the vehicle .
Vehicle Surface
Alternate Outside Antenna
Installation: RV/Trucker Antenna
Select a suitable location to install the
antenna on your RV, as high on the vehicle
as possible and at least 12 inches away
from any other antenna . For best results,
use weBoost 3-Way Mount (#901104) .
This bracket will enable you to mount the
antenna on a mirror or attach it to the side
of your RV .
Screw the six antenna radials into the
holes under the plastic coil housing on the
antenna . The included thread-locker liquid
must be used to ensure the radials do not
vibrate loose . Tighten the radials snugly
with a wrench .
6
Need help?
(E) NMO Antenna
Assembly
Rubber Seal
(D) Threaded Nut
(C) Rubber Washer
Drilled Hole
(B) Plastic Washer
(A) NMO Connector
Cable
www.weboost.com
Add Thread
Lock Liquid
If you are installing on a mirror, clamp the
mount to the mirror support and tighten the
four nuts and bolts . If you are mounting
directly to the side of your RV, remove
the nuts, bolts and the smaller half of the
mount and use the four holes in the larger
half to attach it flush to the side of the RV,
using screws or bolts, nuts and washers
appropriate for your particular installation .
RV / Trucker Antenna
Alternate Outside Antenna
Installation: Marine Antenna
The weBoost Marine Antenna should
be mounted as high as possible with no
obstructions . Marine antennas work on
a "line-of-sight" basis, so the higher your
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm
RV / Trucker Antenna
Screw In Radials
Mount & Hardware