Beper P206VEN130 Mode D'emploi page 8

Ventilatore piantana con timer Manuale di istruzioni
Description of the item Fig.A
1. Front grid
2. Closure nut
3. Nut blades
4. Blades
5. Rear grid nut
6. Rear grid
7. Motor
8. Swing button
9. Body motor
Assembly instructions
Put the base on the floor.
Insert completely the internal pipe inside the external pipe.
Fix the high adjustment handle.
Fix the external pipe to the base with the screw (included in packaging).
Take off the external pipe, and regulate it until the desired height. Strongly screw the high adjustment handle.
Place the control panels on the pipe.
Screw completely with the screw in order that the control panels is well fixed to the intern pipe.
Place the rear grid on the motor, in order that the holes of the grid are well inserted into the motor of the fan
Strongly and completely screw the rear grid in order to block the grid on the motor.
Insert the blades of the fan on the motor and completely screw the nut blade on the motor, in order to block the
body motor.
Assembly the 2 grid front and rear ones by inserting the closure nut, place the front grid, on the rear grid. Close
the nuts to block the grids.
Speed selection
Choose the speed desired pressing on the buttons of the control panels.
Position 0 the fan switch off.
Position 1 low speed.
Position 2 medium speed.
Position 3 high speed.
Timer
The timer can be set from 10 to 60 minutes by turning the knob on the control panel. Once the time set has
expired, the fan will shut off automatically.
Head inclination
It is possible to choose various positions and change the air flow swing.
Before changing it, switch off the fan.
Take the motor body, unscrew the regulation axis and change the inclination of the fan as desired and screw the
air strongly.
Attention: do not try to force the inclination position in order to avoid any failure.
Swing
When pressing the swing button, It is possible to activate or disconnect the swing of the fan, by touching the
swing button. Swing allow to provide the air uniformly.
To activate the push the swig button down until is completely blocked ; the head fan turns automatically from right
to left. To disconnect the swing raise completely the button.
Cleaning
Before cleaning, switch off and unplug the fan.
For cleaning use a soft cloth, that may be softly wet.
Do not use alcohol or chemical substances, or any detergent that could damage this appliance.
Do not spray water or other liquids on the fan in order to protect it.
After cleaning, dry every parts before using the appliance.
During the winter and when not used, keep this appliance in a dry and clean place.
10. Inclination set button
11. Timer
12. Control panels
13. Screw for pipe
14. Internal pipe
15. External pipe
16. High adjustment handle
17. Screw pipe coupling with clamping washer
18. Base
8