Bluetooth Pairing - Soundcore Life A2 NC+ Mode D'emploi

When you're wearing the earbuds, they will not power off until out of battery. When
you remove the earbuds, they will automatically power off after 30 minutes if no
device is connected.

Bluetooth Pairing

1. Open the charging case, the earbuds will automatically enter the Bluetooth pairing
mode.
The LED indicator on one earbud will flash quickly and on another earbud
breathe slowly.
2. Select "Soundcore Life A2 NC+" on your device's Bluetooth list to connect.
When successfully connected, the LED indicator on earbuds will light up white
for 1 second and then turn off.
1
• Each time you power on your Soundcore earbuds, they will automatically connect
to your last successfully connected device if available within the Bluetooth range.
• Mono mode: When Bluetooth connected, you can use either one of the earbuds
only by placing the other one into the charging case and closing it.
• When powered on and connected, if either one of the earbuds is out of battery
and powered off, you can keep using the other one.
• When you are on a call, place either one of the earbuds into the charging case
and close it, the microphone in the other earbud will be activated.
• The right earbud is the primary earbud by default. If you want to change this,
remove the right earbud from your ear and leave the charging case open, the
microphone in the other earbud will be activated. Place the right earbud in the
charging case and close it, the left earbud will become the primary earbud.
2
Soundcore
Life A2 NC+
Soundcore
Life A2 NC+
EN 04