Power Supply; Starting Up The Unit - Nedo X-Liner 4 Mode D'emploi

5 Power Supply

When starting up the X-Liner 4 for the first time, install the batteries (4) supplied, as shown in
the battery compartment.
Insert /replace batteries
The X-Liner 4 requires 4 batteries, 1.5 V
(AA).
• Use a screwdriver to turn the locking screw
of the battery compartment to the left until
the battery compartment cover can be
pulled out from underneath.
• Remove the battery compartment cover.
• Insert/replace batteries as specified.
Ensure pole direction is correct!
• Re-insert the battery compartment cover
and screw the locking screw back in by
turning it to the right. Lightly tighten the
screw.
6 Operation

6.1 Starting up the unit

• Set up or fix the unit according to the intended use. Ensure the levelling
range of ±3° is not exceeded.
• Use the adjustable unit baselegs (3) to roughly level the unit. The
setting can be checked using the circular bubble (4). The X-Liner 4 is
correctly levelled if the air bubble is located in the middle of the circle.
• Lock the pendulum locking device for use without self-levelling. To do
this, push the unit switch into position 1
button to switch on the unit. The laser lines flash slowly (every 4
seconds).
• Release the pendulum locking device for use with self-levelling. To do
this, push the unit switch into position 2
with the ON/OFF button. If the laser lines flash quickly the X-Liner 4 is
outside the self-levelling range. The laser must be positioned within its
levelling range with the help of the adjustable baselegs.
• If you have finished working with the unit, lock the pendulum locking
device and use the ON/OFF button (press for 3 secs.) to switch off the
unit.
Operating Instructions X-Liner 4
1
3
and use the ON/OFF
and switch on the unit
www.rusgeocom.ru
EN
2
If the battery charge is
weak, the LED display (2,
Fig. p10) begins to flash.
If the batteries are too
weak the laser switches
off.
Alignment of the
circular bubble
Wrong
Correct
11