Publicité
L930-B3
Exterior Stake Light
Parts
LED Unit with B3 canopy
Pipe stake
Waterproof wire nuts x 2
Allen key — Included
1) Drill a hole into the side of the pipe stake
for wire to come out.
2) Connect fixture leads using supplied
waterproof wire nuts. Power to the remote
driver must be off while wiring LED fixtures
to drivers.
3) Push pipe stake into soil until pipe stake
leaving enough pipe on the surface to
connect B3 canopy.
4) Attach B3 canopy to pipe stake, securing
with 3 set screws.
4) Direct the fixture head to the desired
direction.
5) Adjust and lock angle of fixture by
tightening set screw (M3) with provided
allen key.
www.mplighting.com t 1.877.708.1184 f 604.708.1185
LED unit
M3 set screw
Allen key
All technical information in this document is subject to change. Copyright © MP Lighting.
B3 Canopy
Set screw
Waterproof
wire nut
Pipe stake
Soil
01-2021
Publicité
