imilab A1 Mode D'emploi page 5

3. Make sure to position the base unit so that the
arrow is pointing up. Secure the base unit in place
by tightening the screws into the plastic anchors.
4. Matching the grooves on the bottom of the
camera unit with the raised area on the base unit.
Press down until the two surfaces are flush, then
turn the camera unit in either direction to lock it in
position.
Warning:
To avoid any damages or injuries, the device must be securely fastened to the
Ceiling/wall as specified in the installation instructions.
When mounting the security camera on a wall:
Please note that the wall must be able to support at least triple the product's total
weight.
EN-03